BIGDRIVER

Hi all,

In replacing rear shocks, the hex key in the strut centre rounded off, so I went at it with an angle grinder. Worked a charm, new shocks in no problem, sits fine. Issue is, as the space is so tight I nicked a fuel line with the grinder. Thank God I'm still alive!

I'm thinking to chop out a couple of inches and bridge the gap with some rubber line and jubilee clips. This seems doable, though I'm unsure how to drain this line before getting out the cutter.

You can see the line in the top right of the picture - I'm guessing it isn't a return line because a few minutes of idle pissed fuel absolutely everywhere.

Any tips much appreciated, as I've never done this before.

Cheers!