Can I use PSCAN to re-code a replacement engine management ECU and alarm or is that beyond its feature set?
I suspect my Engine Management ECU has a fault. The PSCAN software shows no obvious alarms.
Once the engine warms up I get momentarily engine fuel starvation it seems and the engine almost stalls for a split second then all is well for a while then it dips again. The engine will very occasionally stall.
My classic MG garage has changed sensors, fuel valves and tried all sorts etc. All except a new wiring loom. (Note: This fault started immediately they installed a new clutch, could be a coincidence)
If I swap out the Engine management ECU for a replacement the garage says it won't work due to mismatch with the alarm system?
I'm in Sydney Australia so having to physically send an ECU & alarm back to UK to be re-configured is a very expensive option especially as I'm not sure its the cause of the problem yet.