When I bought my TF 3 1/2 years ago the sill ends of my car were very similar although this issues didn't rise up the wheel arches. As it was a very good car mechanically I went ahead and bought it.

The following year I ground off all the rust and applied a rust cure and paint. Late this year I was able to put my finger through small holes that has appeared on the inside of the front sills. I've had it looked at and been advised that both can be repaired relatively easily without going down the full Mike Satur repair panel route.

Hope this helps.

Read More...

neilpinleeds replied to the topic 'TF Remap Insurance' in the forum. 3 weeks ago

With F/TF values where they are it would cost an insurer nearly as much to interrogate an ECU as the cars value. They would just pay up if the damage did not involve personal injury.

Read More...

Yes, MGTF Bitz have a repair kit with both arms for £30.

Read More...

No, it only works on the top; square edge to square edge. Even if it would open wide enough to go onto the bottom link, the motion of the round area it would sit on would ping it off...

Read More...

Looks like the clips work fine if it is the top part of the link/bush that has failed, but not when, as in my case,

   it is the bottom half?

Read More...

If these engines were used in other vehicles did those other vehicles have the similar head gasket failure propensity?
A Google on this suggests there were other factors such as who produced the cylinder liners and possibly who built the engine. Lotus is mentioned but did they just take the engine for their purposes or did they modify it with regards to head gasket etc?
Anyone have “history” on this, and if so what is now the accepted wisdom should a new gasket be required?

Lotus partially stripped the engines including fitting an upgraded head gasket. HGF is not unknown on the Elise though either. I visited the Lotus factory in 2000 and they had a warehouse full of K Series engines stacked 10 high, quite a sight.
 


Read More...