SALAD DODGER

Cobber wrote:

ashleyfrazer wrote:

Hi
Could someone scan these increasingly hard to find parts and 3D print? Ash

Sent from my SM-S908B using Tapatalk

These and the fog light mounts are the sort of parts that are made of unobtainium, but would be easy to 3D scan and print.
The other thing that would be handy for fitting these would be a copy of the fitting instructions, the cutting template in particular.
Though I suspect all of those would’ve been thrown out or fallen to bits long ago.

Salad Dodger, you could take the one from the other side and have it 3D scanned, then they can flip it over on the computer to give the correct coordinates for the opposite side then they can 3D print that.

I did actually find someone who has indeed 3D printed these fog light trim rings but they sell them for around £35 each which I think is a bit expensive though I doubt they sell many of them due to there not being many cars that actually have them fitted. If you look at it in the way that some buyers would need two of them, it does make it a bit of an outlay for many owners. I had a hard job to even find a replacement fog light. Even when I found one it wasn't the same as mine. It required a different bulb so I changed the connection plug to suit.
This is the link for the 3D printed rings: This email address is being protected from spambots. You need JavaScript enabled to view it.