Sign In   Register
Introduction
Pinned Items
Recent Activities
  • Thanks for the reply.

    The fobs are brand new and they were coded by Paul at Technozen. The fobs are working, locking unlocking and disarming the alarm. Also the car was running good before the old fob gave up 😀
    1. View Reply
    2. View Thread →
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • Mario5 created a new forum post in pscan.uk diagnostic tool forum
    Hello, Im trying to learn ems code on MG TF 2004 after programming new fobs to the scu and after I learn EMS code with pscan the engine starts and runs no problem.
    Turn off the engine lock unlock with fob the engine will start and will cut out in 1 sec.

    Everytime I re-learn the ems the car will run with no problems.

    Switch off the engine for a few seconds sqme problem.

    Anyone have any idea, should I replace the ecu or the scu.

    Thanks
    1. View Thread →
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • Mario5 unlocked the badge Newbie
    Newbie
    Being part of a community. To unlock this badge, you need to register on this site.
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • Mario5 just registered on the site
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
There are no activities here yet
Unable to load tooltip content.
© 2024 The-T-Bar.com All Rights Reserved. Hosted By SEBS IT