Sign In   Register
Introduction
Pinned Items
Recent Activities
  • wbvreeuwijk thanked the user mowog73 in the forum post, Heater replacement
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • wbvreeuwijk created a new forum post in MGF/TF Pitstop
    Hi All,

    I'm considering the replacement of my heater assembly of only the heater rad. As far as I can see there seem to be only parts for the MG TF available. Are these interchangeable with MG F parts?

    Thanks in advance,
    Bas van Reeuwijk
    1. View Thread →
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • Small update. I found the keys again :-)
    1. View Reply
    2. View Thread →
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • Thanks, that's helpful information. Yes, we've already had an issue with the keys being in the boot and then having to pop the boot from the engine compartment however in that case the car was unlocked.
    You're probably right that when we have all the locks replaced and the key fob matched to the car we will find the original key :-)
    1. View Reply
    2. View Thread →
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • wbvreeuwijk updated his profile picture
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • wbvreeuwijk created a new forum post in MGF/TF Pitstop
    Hi All,

    My son has lost the keys and fob of his MGF (1999) so it is currently in a locked and armed state.

    So I'm seeking the guidance of the wise men and women of this forum to answer a few questions I have
    1. For the locks I can either pick them or forcibly remove them and replace them with secondhand or new parts. Anything I need to know about? Can someone share their experiences with a similar situation?
    2. For the missing fob I can either replace the ECU, Alarm unit, and Fobs as a matching pair or get a new fob and use Pscan to match the fob with the ECU and Alarm unit. Is this assumption correct? What is the recommended approach?

    Any other tips or tricks will also be highly appreciated.

    Thanks,
    Bas
    1. View Thread →
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • wbvreeuwijk unlocked the badge Newbie
    Newbie
    Being part of a community. To unlock this badge, you need to register on this site.
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • wbvreeuwijk just registered on the site
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
There are no activities here yet
Unable to load tooltip content.
© 2024 The-T-Bar.com All Rights Reserved. Hosted By SEBS IT