Having had the rear subframe out of my MGF for a strip, clean and rebuild the engine has been reluctant to start from cold but fine when it gets going.This afternoon, having replaced the fuel pump and cleaned tank/filled with clean fuel I got the engine running smoothly once it overcame its reluctance to fire. Note that the oil temp gauge is currently disconnected and I would expect this to have an impact on the engine control unit.However, having turned the engine off and back on again the dash lit up like a Christmas Tree (see attached photo), hazard lights started flashing and a beeping noise was coming from somewhere. Having just purchased a PSCAN I connected this to the car and received a long list of errors (see attached). Can anyone make any sense of this situation and suggest where I should start with my fault finding?