ORIO

I fitted a tow bar to my 1997 VVC MGF OK
I was lucky to get hold of a “Watling Eng.) tow bar piece that fits under the MGF rear bumper just between the crash cans and drops down to meet the up angled 6” tow hitch bit and the towards front of car under support. The smaller bit to the tow hitch I made from 2 bits of angle iron 40x40x5, these fit to the angled drop down plate following the flat surface (missing the bumper lower edge by just about 5mm).
I did intend to follow the original design with a massive box section to the main under pan plate under the dead center of the car. But when I got hold of the steel it weighed a ton, massively over engineered. So I looked around under the car for a better solution? And found an obvious one? In the center of the rear cross-member of the back sub-frame is a strange dropping down bit of round metal bar almost ½” diameter rod with a metal strengthening plate welded to it. This bar is very well weld to the rear sub-frame and is ten times stronger then the 3 or 4- 8mm bolts the massive box section would have fitted to. So I made up 2 lengths of slightly smaller angle iron 30x30x5 to drop down at an angle around the whole exhaust system to my fixing place. Plenty strong enough without putting any real strain on the rear sub-frame. Plus there is more ground clearance the way I forward fixed the tow bar.
My system must be ½ the weight of the full Watling Eng. Tow bar, but it depends what you want to tow I guess, how ever I would recommend anyone to either get that key under bumper bit or ask to buy just that from Watling, I am pretty sure they would sell just that on it’s own? To someone who could give a Reg. for a pre. 1/8/98 car. These have been fitted to later cars and the TF but at ones own risk as after 1/8/98 the EU forced one of many since Type Approved laws down our throats, just like with the CATs, Head lights Etc. BTW Older cars are not affected like the MGB.
Some may say why would you want a tow bar on a sports car? I would say why not 
I will do some photos come the better weather.
I have borrowed a couple of other peoples photos for now and have adjusted some. Plus a shot of a MGF rear sub-frame to show a welcome alternate front fixing point (see red marks), a better job for lighter towing I think. ORIO