Introduction
Groups (0)
No groups yet
Pinned Items
Recent Activities
  • I finished putting aluminium coolant pipes under my F The old ones had a pin hole in one of them. I had to flare the pipe as the first time I did it the rubber hose just slipped off when it got up to temp & pressure. I did it in 4 pieces of tube & just used the rubber for the bends in the front, I was able to throw a fair bit of the rubber hose out & made the tube go closer to the radiator. It should add to the cooling capacity as well.
    I cleaned the radiator out too it probably only had 60% of its tubes open. I used a long piece of copper to push gunk out.
    1. View Reply
    2. View Thread →
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
There are no activities here yet
Unable to load tooltip content.