Sign In   Register
Introduction
Pinned Items
Recent Activities
  • Borypops created a new forum post in MGF/TF Pitstop
    I have replaced both diff seals in an attempt to stop leaks,there is movement on the diff bearings the gearbox works with no problems,as I have already reconed all of the running gear and engine i don’t fancy having to drop the subframe again ,my question is has anyone removed the gearbox without doing so


    Sent from my iPad using Tapatalk
    1. View Thread →
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • Well, I will check after a few thousand km's how much has leaked out, by refilling it.
    According to the garage to solve it the complete gearbox should be replaced / overhauled, but looking at the diagrams an option could be to change the diff bearings, These seem accessible from underneath the car with the gearbox in place. Too much play will likely be caused by worn bearings I think. The only thing is, if these are pressed in, removal won't be possible, but according to the diagram the bearings are held in place by a snap ring, which would make things easier.
    I will also check if the correct oil seal has been mounted by the garage.


    You can’t replace the diff bearings with the box on the car sorry, same problem my self 😤


    Sent from my iPad using Tapatalk
    1. View Reply
    2. View Thread →
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
There are no activities here yet
Unable to load tooltip content.
© 2024 The-T-Bar.com All Rights Reserved. Hosted By SEBS IT