i swapped my temp and clock over while the top vents were out, you can just reach down.
top of console levers out an inch or two, swapped bulbs at the same time.
Good tip that ill bear it in mind when I LED the clock n oil gauges
When does the fog light job start? I'm going to tackle mine soon but I remember you said you'd do a how to.
It's always easy to learn from someone else's experiences.
Id just buy a pre-made loom from eBay I won one for £4.00. I'll start a post up for you and people can add. Should be easy enough to butcher an existing loom and fit the proper TF switch.
Surrounds clip off and with a bit of grinding / filing you can get the others to fit then a few bits of magic epoxy resin and jobs a gud un not sure fof the chrome handles yet I'm going to keep the TF squarer ones
Bogey had a different look today courtesy of handing over £115 hard earned pounds
It's not perfect the lining might get replaced has a few chips and a dint at the front but.... Bit of filler and either touch up spray, plasti dip or properly paint it