Topic

pendle lass wrote: wrote:

Hi Marco, we had a lovely holiday in Italy lasy year............. every day being a roof down day

Where were you exactly? Nice travel! A lot of miles from GB to Italy!!!

Inviato dal mio STX con Tapatalk 2

We were in the Lakes, it was a fantastic holiday, have a little look here for the photos etc

We met up with some members TF Passion too

http://www.the-t-bar.com/en/forum/18-past-events/27143-the-border-patrol-italian-run?limitstart=0

Hi Marco

Where in Italy are you?

We visited Italy for about 6 hours last summer on route from Monaco to France.

We are planning to spend a bit longer this summer.

James

I live in Monfalcone, few miles from the Slovenian border. I'm with you, 6 hours are not enough!

Marco

Lots of knowledge and expertise here!

look forward to hearing about the fun you have with your lovely TF

John

KentJohn wrote: wrote:

Marco

Lots of knowledge and expertise here!

I'll need it soon! Leaks leaks leaks

Is this the right topic to ask help?

Yes, this is the place to get help with any problems
Not me, but there are members on here that can solve most problems.

Ok, I go...

since I removed door cards to change the door lock, I decided to fine tune the windows to eliminate the leaks. So I have followed the howtos found here and on mg-rover forum. But something went wrong, because leaks got graeater, mostly on driver's door, left side in Italy.
So I have to manage again to get a good contact between glasses and rubbers, but I need some info:

1) glasses have to push on the cantrail from down to up, it's correct? Or outside to inside?

2) If so (down to up), to achieve a good seal I have to let the glasses to rise a lot, and then it become hard to open or to close the doors.

3) as doors get close to the rubbers, rubbers push the glasses outward, and if I want the glasses to stay underneath the cantrail I have to push them by myself, which doesn't seem to be the correct behavior. Is it?

A picture of the rear mirror: rubbers are ok?



Thank you for everything!
Marco

Hello Marco and to the forum