Sign In   Register
  • Hi, the inline fuse is on the thick brown wire going into the relay.
    I have pulled the relay case off to look inside and as you can see its perfectly intact with no signs of burning which is a shame as it would have made lots of sense, ( a dead short ) but going through the coil, on testing it i get 65.7ohms through pins 85 & 86 which is across the coil then open circuit on pins 87 & 30 & then a dead short when the contacts closed. however, checking the resistance of the coil again, i get the same reading closed or open but as you close the relay i get an audible tone of continuity just for a nano second but doesnt show that on the LCD display.
    Also is the switch supposed to be latching or not .
    1. View Reply
    2. View Thread →
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
Unable to load tooltip content.
© 2024 The-T-Bar.com All Rights Reserved. Hosted By SEBS IT