Sign In   Register
  • As with a number of my jobs this one wasn’t finished off because it worked fine as lashed up. The Mk2, which was mounted in the same way but with improvements in geometry, a more refined fine adjustment rod to the latch. That iteration went when I sold the tf & I’ve been messing with other stuff, I’ll revisit it probably soon as looking at it this afternoon has reenforced its shortcomings.
    The actuator obviously mounts to the latch frame, the latch rod is actually a piece of wire with a loop which shares the same hole through which the key mechanism boden cable passes. The brown drop plate is an odd bit of SRBP with a couple of holes drilled at centres equal to the centreline distance on both actuator & latch pull. Finally the screw assembly which serves as adjusters & wire clamp is a repurposed bike mudguard stay screw.
    I should have swapped the Mk2 design from the tf but we were old friends & I was sad to see her go, it didn’t occur to me really until today.
    I hope this helps sort out any mysteries Mike.
    1. View Reply
    2. View Thread →
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
Unable to load tooltip content.
© 2024 The-T-Bar.com All Rights Reserved. Hosted By SEBS IT