Sign In   Register
  • Bruce the round thing is the mounting hole for the wing mirror which incidentally when I took it off had a broken mount so one bolt had been replaced with a 3" wood screw. I wondered why that screw cover didn't sit flat now I know.
    I got the rubber channel out in the end, it is only glued in but I had to save it as I could not find it separately online, if anyone knows differently let me know as if this works I will have to do the driver's side (again).
    I have now with a judicious bit of filing managed to cramp the cheater/bottom channel joint over by about 1mm which I hope will bring the top of the cheater in by about 4/5mm. When I adjusted the driver's window I found it impossible to get the cheater to align with the screen pillar and gave up. Since then I've looked at the cheaters on every TF I see and most have the same problem so it's not just me.
    I've taken a couple of pics and if it works (fingers crossed) I will post them with an explanation.
    1. View Reply
    2. View Thread →
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
Unable to load tooltip content.
© 2022 The-T-Bar.com All Rights Reserved. Hosted By SEBS IT