Cheers Tom, I may just have to ask about door alignment, my driver door is way out - almost looks like it is open from behind!
I'll have a dig around the forum and see if I feel brave enough to have a go at it...
I had a similar issue, you need a ratchet and a torx bit to fit the striker plate (which the latch locks onto, attached to the door frame), if you loosen it you can tap it until it moves in a bit then tighten it and try shutting the door, small movements are best, make sure that you wind the two rubber ‘stops’ in on the edge of the door first, as these might have been wound out to compensate! You can wind them out to suit once the door fits better! Also, before I start I draw round the striker with a marker, it gives you a reference as you can move it in any direction so it’s good to see just how much and where you’re going
Lastly, if you move the door a lot, you may need to adjust your windows when you’ve finished, there’s a decent guide to it on here, however, make a note of how your window sits in the seal before you start.. and it WILL be frustrating.. but it’s amazing once it works, which it will!
Sent from my iPhone using Tapatalk
