Sign In   Register
  • I made a spacer to centre the rear silencer which needed moving over a little. I used a piece of 7/8" Tufnol tube which I cut a section out of to make a C section and drilled a hole which was then extended to the edge in order to make a clip on fixture that would holsd itself in place. It worked like a charm. Delight. I finished polishing the lacquer on the sill where I had fitted a repair panel. I wasn't quite happy with it and wet sanded it again before frightening it with power tools. I stood back and looked at the result. If you look for them, you will always find the flaws so I asked myself: had I paid to have this done, would I be happy with it? Actually, yes. so that is done then. The microphone for the radio arrived as did the DAB antenna but I am still waiting for the speakers for the t-bar. Once they arrive, I shall get enthused with the audio system. I have one bolt to replace under the bonnet, the one for the battery earth which will need to be removed once I have shunted the terminal to earth.
    1. View Reply
    2. View Thread →
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
Unable to load tooltip content.
© 2022 The-T-Bar.com All Rights Reserved. Hosted By SEBS IT