Sign In   Register
  • At the moment I am thinking of the AP one, due to a bulk buy they are nearly as cheap as the B&B
    I have not looked to see if the clutch shaft is hardened, if not I might try drilling a 2mm hole up the shaft and then cross drilling for the grease to exit. A M6 grease nipple on the end and you are done. If it’s hardened then I will look at Mike Satur’s ready made solution.
    1. View Reply
    2. View Thread →
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
Unable to load tooltip content.
© 2024 The-T-Bar.com All Rights Reserved. Hosted By SEBS IT