Sign In   Register
  • shambo created a new forum post in MGF/TF Pitstop
    I'm using TF subframes with all the suspension and steering parts, including the column and EPAS unit to go into my Mk2 Metro project.  What I'd like to know is, can I use the single passenger rear speed sensor to feed the EPAS with a speed signal or does it need to go into the engine ECU first?  I'm asking because I'm not using the BCM or ECU from the TF for this project so need to find a way around it if I can't feed it directly from that sensor.  The doner TF has no ABS, just the single sensor.  I've found it in the wiring diagram referred to as rough road sensor?  If that's the correct thing I'm looking at?

    Other ramblings for the moment are along the lines of wheel bearings and hubs, I'm looking to use a different hub and wondered if anyone knows, short of me pulling a bearing apart, how thick the inner race is so I can decide whether to turn it out a little or machine down the hub I'm going to be using.  I have a total difference in diameters of 2mm and was toying with the idea of either:

    A - turn down the hub 2mm
    B - turn down the hub 1mm and increase the internal diameter of the bearing 1mm
    1. View Thread →
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
Unable to load tooltip content.
© 2024 The-T-Bar.com All Rights Reserved. Hosted By SEBS IT