Sign In   Register
  • Thanks for all of your replies.

    As I am fortunate enough to have an old spare hood frame I have managed to remove the other 3 shoulder bolts virtually intact by heating up to 300f but each snapped at the tip but are still usable. It appears that they were probably welded in at the ends.

    I decided to take the bracket to a local engineering firm to remove the snapped bolt which I hope will be ready to collect tomorrow.

    For reference the shoulder bolts are M8 (10mm) x 12mm with a 17mm hex head
    1. View Reply
    2. View Thread →
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
Unable to load tooltip content.
© 2024 The-T-Bar.com All Rights Reserved. Hosted By SEBS IT