Sign In   Register
  • Adam M created a new forum post in MGF/TF Pitstop
    Last Tuesday went out for a drive pulled up at a junction and the car just cut out, Restarted fine and off I went got caught at a set of traffic lights and the idle was poor and kept stalling.
    Scanned it with a OBD2 tool came back with P0340 (camshaft sensor) I have already replaced this last year anyway after a bit of digging around the engine bay I found that the pre cat lamba sensor wire had melted so I fitting a new one and the car now runs fine however it has a very slight lumpy idle after doing another scan came back with the same code P0340 so I robbed the sensor off my ZS. and it's still the same the code comes back when ever it's cleared, I check with a multi meter and there is still power to the sensor, So I'm at a lost?

    MG TF 135
    1. View Thread →
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
Unable to load tooltip content.
© 2024 The-T-Bar.com All Rights Reserved. Hosted By SEBS IT