Adam M

Is there any planes for being able to enable extras like front fog lights on my MEMS3 ZS?

Is it possible to use Pscan to copy my old ECU to my new one?

It was just the wiring for the lamba sensor that melted it was a cheap one any way, But that has been replaced.

Last Tuesday went out for a drive pulled up at a junction and the car just cut out, Restarted fine and off I went got caught at a set of traffic lights and the idle was poor and kept stalling.
Scanned it with a OBD2 tool came back with P0340 (camshaft sensor) I have already replaced this last year anyway after a bit of digging around the engine bay I found that the pre cat lamba sensor wire had melted so I fitting a new one and the car now runs fine however it has a very slight lumpy idle after doing another scan came back with the same code P0340 so I robbed the sensor off my ZS. and it's still the same the code comes back when ever it's cleared, I check with a multi meter and there is still power to the sensor, So I'm at a lost?

MG TF 135