I would add an additional 35cm so total length including original wire = 52.5cmFor us stupid ones, what length of wire would you suggest?
I only asked because if you were near me in Coventry I could plug my Pscan inI'm based in the county of Rutland which is East Midlands. Thanks for the well wishes I'm hoping the interview goes well
P.s. I made a spelling mistake in my last post. I meant OBD reader not "OBR reader". Just tested again and can connect but still cant find any fault codes.
If you do sell the three ring I would be interestedI had a pair on my TF. The lense is slightly tinted, but the plastics behind are black. Its enough to look dark smoked, without restricting any significant light.
I think smoked rear lights only look good on dark cars, such as black, and possibly red cars.!
Still got them, must list them for sale sometime when lockdown comes to an end.
Also have 2 or three sets of 3 ring lexus style (with the bubles over the lights). Was going to convert them to smoked, but now my TF has gone, so just sitting in the garage.
Found this picture of the tinted lights
Hi where in the country are you based ? Good luck with the interview
I would put the mg away for now and self isolate for a while..just too much going on there for a unemployed person to cope with.
Now the lockdown is over I phoned the garage since they hadn't replied to my email. I explained the problem (yellow engine light after a full engine replacement) and that all my OBR reader could tell me was it was an issue specific to the make of car. He replied that he was 99 percent certain that the problem was with the oxygen sensor in the exhaust as OBR readers wont display this specific issue.
He wants me to take it into the garage next week and have it looked at and i'm terrified that i'm gonna now have to buy a new exhaust. What does this mean for me and what should I look out for? Anything I can do before I take it back to him to make sure its the oxygen sensor?
P.s. i've got a job interview this friday, whoop whoop!