Sign In   Register
Introduction
Pinned Items
Recent Activities
  • I have a TF too and never had a problem clearing codes, even if they come back. On the ZTT the pscan won’t clear any of those codes. It just throws up an error $22.

    I have tried pressing delete several times.
    1. View Reply
    2. View Thread →
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • Thanks for the link, but my issue is not the error codes themselves, it’s that I have changed the vis motors but Pscan wont clear any error codes.
    1. View Reply
    2. View Thread →
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • jbecker84 created a new forum post in pscan.uk diagnostic tool forum
    Hi there,

    I have an MG ZT-T 180 and I have recently replaced the vis motors. I am trying to clear the error codes p1472 p1475 and p1477 but when I attempt to do so I get error code $22 and they won’t clear. Has anyone encountered this issue and do you have any advice on how to proceed? Many thanks!

    Jacob
    1. View Thread →
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • jbecker84 just registered on the site
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
  • jbecker84 unlocked the badge Newbie
    Newbie
    Being part of a community. To unlock this badge, you need to register on this site.
    0
    0
    0
    0
    0
    0
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
There are no activities here yet
Unable to load tooltip content.
© 2022 The-T-Bar.com All Rights Reserved. Hosted By SEBS IT